![]() ![]() just seems strange to have 11v from a 12v only psu. although a small potentiomiter would be less likley to fail.Īlso i thought it was a standby wire. I could use a potentiomiter but the diodes ar like £1 for 50 of the things. ![]() the diode will naturaly "due to not being efficient" drop it from 12v to 11.3 I can just pull 12v from the psu and throw a a1n4005 diode inline. (i see most of them just used the standard psu, then they jumperd the atx psu to power a gpu.) so it would be nice to do it and confirm it so others who wanted to do it can do it. And having actually looked at it i think the answer is yes. I have also seen multiple posts on the internet asking if it can be done. The only 1 im worried about is the brown wire, but agdain i know a1n4005 diode will drop it down to 11.3v if thats neded. theres plenty of 12v lines on an atx psu for me to use, and i can even use the +4 pin for cpu if i need more.īy looking at it you keep the +4 part of the 20+4 and 12 aditional holes and those all line up and its just shorter) I dont want to hack up a psu when £3 will get me an extender cable i can modify in to an adapter. Im just wating for a 24pin extender cable to be delivere, and will just modify that, (like i said its a standard layout for the atx plug. if not just for me also for the others who wanted too. I will upload a small "very porly made" png i scetched out earlier in paint as i was testing the outputs.īecause it seems the pinouts for these psus is a guarded sceecret, and no one else who had one had a multi meeter.īut for now im going to be trying to run this off a atx psu. The 4pin connector really does not seem to be needed at all if you were using a standard atx psu as its only for supplying sata drives. The plug is a standard atx plug its just shorter, and the wires are in the wrong place. I dont see any reason why i cant swap this out with a standard atx psu. In theory i should be able to use a diode inline which would naturally drop off 0.7v giving me the 11.3v (but why doo that if its not needed and create a possible failure point.Īlso i have seen people all over the internet with these things and they just gave up. What i really want to know is Can i use 12v on the wire that has 11.3v I THINK this is possibly a 12v standby, but im not certain. which is 11.3v dont ask me why but it is. theres a grey one which i think is a power ok check. I got the multi meeter out and all the yellow wires are 12v all the blacks are ground. so its a propriatary connector 16 pins + a seperate 4 pin. Im going to skip the long story and just come out with my main issue. So seems good for a simple build, BUT its not really. Ok so i have this fujitsu esprimo c700, Its not terrible specs really for a tin thting.Ĥram slots 1x pci-e slot 3 Sata ports tin little motherboard M-atx or something similar with an i5-2400. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |